In an effort to maximize the shop opening time for as many members as possible, it was decided today by the wood shop board of directors that members having an appointment to use the shop must sign in for that shift no later than one hour after the start time of the shift, i.e. nine […]
Category: Shop Policy
Wood Shop and Website Access IMPORTANT
This is important! PLEASE READ! TENANTS: IF you are a seasonal TENANT in Green Valley, your GVR card is valid ONLY during your tenancy. You MUST ensure your GVR Card is valid with GVR by submitting required paperwork and or dues otherwise it will NOT work in the wood shop. IF you change your rental […]
Monitors UPDATE (Nov 2020)!
1. Monitor Shifts: Monitor Duty shifts are now Open and available for sign-up through April 30, 2021. Go to the Monitor Calendar to schedule your shift. 2. Monitors with Lockers: Only “Active Monitors” may rent a locker. To be considered an Active Monitor, the Monitor must perform at least ONE (1) Monitor duty shift each […]
Pick Up Club Badges!
NOTICE!! To All Members who ordered a Club Badge…Please pick up your Club Badge at the Monitor Station!
Shop Reopening Plans Update June 18, 2020
I wanted to update the membership on the shop reopening plans or what I know about them at this point. Many have asked if we have a plan submitted to GVR and I can assure you that this has been accomplished and GVR has the re-opening plans in their possession. Last week the GVR board […]
Wood Shop Reopening Plan UPDATES
Return here for newest information regarding a reopening of the wood shop. PLEASE refrain from sending emails or making phone calls to the board members as we do not have the time to address each individually. We will also post information on the What’s New Blog page for members who are logged in to the […]
Reminder: Patio Is Not To Be Used For Storage
Members are not permitted to store materials on the patio. If materials are seen stored on the patio, they will be discarded.
Toy Saw Blade Has Brass In It
Pieces of brass were found in the toy saw blade. A reminder that no member should cut any metal (including brass an aluminum). It is possible that the saw was used to cut down a pen blank. Please sand off the excess brass tube in a pen blank or use the pen mill.
Wet Glue On Machines an Ongoing Problem
Work with wet glue must never be used on any machine. Wet glue ruins sandpaper and the paper must be replaced. Please allow the glue to dry for 24 hours before using the belt/disk sanders, the thickness planer etc. While some members are aware of the issues using wet glue on the sanders, many do […]