SawStop Saw Blade Wobble

Lats week, a wobble was discovered in the blade of the new SawStop saw. Gary Riecke measured the deviance in the blade at about 20 thousandths of an inch. This wobble produces a kerf greater than 1/8″, actually 1/8″ + 2x 20,000 thou. If you are doing rough rip cuts, the wobble should not affect […]

Read More

Pay Dues for 2021 AND 2022

Pay Dues for 2021 AND 2022 If you did not pay dues for the current year (2021), this is a reminder to pay them before December 31.  You cannot skip a year of dues.   If you do not pay for 2021, you may be required to take Orientation classesIf this year’s dues (2021) is not […]

Read More

Shop Closure-Dec 28-29-30

GVR will be installing anti slip flooring in front of the lathes, jointer and planer. This is a three day process. The shop will reopen on December 31, but GVR may tape off the newly coated areas if they are not fully dried and cured. Please stay out of these areas if they are taped […]

Read More

Giving Back

Please consider taking monitor training and working shifts as a monitor. The shop cannot run without monitors and will, in fact, close if there is no one willing to monitor. We have almost 500 members. If you look around, it is always the same people who do all the requisite volunteer work in the shop. […]

Read More

Jointer

Some prohibited materials were run through the jointer a few days ago. The cutting tiles (all 241 of them) had to be replaced and set up. These tiles are very expensive and incredibly time consuming to replace. Replacing one or two damaged tiles is not too bad, but to replace all the tiles is most […]

Read More

Election Results

Congrats and thanks to those who ran for Board positions for 2022 onwards. Newly elected were Jim Huprich, Bruce France and Dick Sutherland. Stewart Tagg PresidentBruce France VPSecretary John JacksonTreasurer Richard (Dick) Sutherland Directors at large: Jim Counter, Jim Richardson, Tom Cavanagh, Jim Huprich, Steve Mawson. Liaison Committee: Stewart Tagg, Bruce France and Tom Cavanagh. […]

Read More

Sharpening Wheels

It seems that some members are not using the correct wheels. Green is for carbide sharpening, white or grey is for HSS. The green wheel should NEVER be used for HSS. The CBN wheel is meant only for finish grinding of turning tools.

Read More

Maintenance Update

Lathe # 5 The #5 lathe continues to be a bit of a mystery and is still out of service. There are few options for dealing with this tool – buy a new power inverter for it; replace it with a new lathe or remove the lathe to create needed extra space in and around […]

Read More